Place a long strip of painter’s tape or masking tape along the entire length of the PVC pipe.Single-sided, one-hole pipe straps (metal or plastic straps for mounting tubing or electrical conduit.Electric power drill with drill bit set.½ to ¾ inch PVC pipe with Schedule 40 thick walls (enough to cover the length of your wall of tanks).Depending on how many tanks you have and how deep your aquariums are, you may need to get a more powerful air pump. For an entire fish room of tanks, consider upgrading to a central air system that runs on a linear piston air pump.įollow these steps to learn how to make a DIY gang valve that can run off an air pump that uses normal aquarium airline tubing.For a wall of fish tanks where a 4-way gang valve is not enough, we recommend making your own gang valve out of PVC pipe (using our instructions below).The 4 outlets each come with their own air valve so you can individually adjust the air flows or shut them off completely. It comes with 2 inlets, so you can use either the single- or dual-outlet air pump. For 2–4 tanks on a vertical rack, a 4-way metal gang valve is great for sharing the air.However, you may need to add two air valves (one for each route) so you can balance the amount of air flow each tank is getting. If you only have a single-outlet air pump, you can use a T airline splitter to split the airline tubing into two routes. 2 tanks next to each other can share a dual-outlet air pump.As you may know, we are big proponents of using sponge filters in all of our aquariums, but what happens if you have multiple tanks running sponge filters? Is there any way to save money (and improve cable management) by only using one air pump to run all the filtration? It depends on how many tanks need air and how strong your air pump is, so here are some different configurations to try:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |